| Home > Craftsman Clubs > BBS > Woodworking Tips > sander tubes |
|
| Woodworking Tips Moderated by root |
Post Reply | Post New Message Login | Join Craftsman Club | Return to Thread List |
| Not Logged in. | |
| View: Flat [Tree] | Font: [Small] Large | |
| Author | Subject/Content |
| Chuck |  sander tubesSeptember 26th, 2004 02:25 PM If I understand your question, there's a nut and washer on the top end of the spindle. You put the washer on after sliding the sanding tube onto the threaded rod. As you tighten the nut, it expands the rubber tube. This should hold the sanding tube itself from moving up on the rubber tube. Did I help? |
| Up one level | |
| View: Flat [Tree] | Font: [Small] Large | |
![](/BBS/spacer.gif"){kind=spacer} |
|
| Post Reply | Post New Message |