| Home > Craftsman Clubs > BBS > Craftsman Tool Collection > Ratchet Mallet |
|
| Craftsman Tool Collection Moderated by root |
Post Reply | Post New Message Login | Join Craftsman Club | Return to Thread List |
| Not Logged in. | |
| View: [Flat] Tree | Font: [Small] Large | Pages: [1] | |
| Author | Subject/Content |
| Adam |  Ratchet MalletAugust 16th, 2008 01:15 AM I found my Craftsman ratchet mallet, while digging around in one of the ball-bearing Project Center drawers. It's similar to a 1/2 inch drive Long-Lever ratchet. But, its got a black-plastic mallet head where the drive bit would normally stick out and the mallet head is held in place by a T-nut and chromed acorn nut, where the socket quick-release button would normally be. The ratchet blank is a mn 44985, series VF, with FORGED IN U.S.A. on the rear panel. There's even a black-finished, double-crescent selector lever installed, serving no useful function - other than looking marvelous in its unbeaten condition. It's STRONG too! I bet I could SMASH this here mouse. Better not. It's a GUI - needing the mouse. What can I smashify with it? That acorn nut looks like a little... Ball, off a ball-pein hammer. :) Sunflower seeds? |
| View: [Flat] Tree | Font: [Small] Large | Pages: [1] | |
![](/BBS/spacer.gif"){kind=spacer} |
|
| Post Reply | Post New Message |